+ 17. B-2. 721 - 1440. 10-450-9810-000. + 16 ... DC. DC. GND. VT. -1 A = 2. 25, B
= 2.07 .102 DIA THRU. 4 PLACES. SMA FEMALE CONNECTOR. RF OUT .09.
18
SC-CUT OVENIZED CRYSTAL OSCILLATORS
These SC-Cut crystal oscillators are designed for high performance applications where temperature stability, low phase noise under vibration and rugged construc-
tion are a must. A wide range of frequencies and options are available including improved spurious and harmonic performance.
ELECTRICAL SPECIFICATIONS
ENVIRONMENTAL SPECIFICATIONS
Frequency Range: Frequency Set Accuracy (+ 25 °C): Frequency Stability vs Temperature: Aging Rate: Power Output: Phase Noise: Spurious: Harmonics & Sub-harmonics: Note 1 + 8 to +10 dBm output:Note 2 + 16 to 19 dBm output:Note 2 Output VSWR: Supply Voltage: DC Current: 60 to 120 MHz (less heater): 120 to 1440 MHz (less heater): Heater turn-on current: Heater current, steady state:
60 to 1440 MHz ± .05 ppm ± .1 ppm 2 ppm first year See Tables See Figure 1 - 80 dBc, typical
Standard Operating Temperature: (See Option - 002 for - 54 to + 85 °C.) Vibrational Sensitivity:
0 to + 70 °C 5 x 10-10 /g, typical
MECHANICAL SPECIFICATIONS See Outlines
OPTIONS - 30 dBc, maximum - 25 dBc, maximum 1.5:1, typical + 12 to 18 volts
- 002 Extended Operating Temperature: - 54 to + 85 °C (± .5 ppm frequency stability) - 010 Frequency Trim: A mechanical adjustment for trimming the frequency to within ± .05 ppm at room temperature.
60 mA, typical 90 mA, typical 350 mA, typical 150 mA, typical
- 020 Electronic Tuning: ± 2 ppm, minimum
Typical Phase Noise 100 MHz
SSB Level (dBc/Hz)
O S C I L L AT O R S
Fundamental and Multiplied Crystal Oscillators 10-400 & 10-450 Series
-60 -70 -80 -90 -100 -110 -120 -130 -140 -150 -160 -170 0.01
- 090 Combines Options - 010 and - 020
1000 MHz
- 300 Phase Noise Test with Guaranteed Phase Noise Performance Note 3
0.1
1 10 Offset Frequency (kHz)
100
1000
Figure 1
Note 1: “Sub-harmonics” refers to the unwanted multiples of the fundamental crystal used. Note 2: See Tables III and IV for models with - 60 dBc harmonics and sub-harmonics. Note 3: Option - 300 is only available on orders for two or more identical oscillators that incorporate option - 090. Specifications are subject to change without notice.
ABC
4726 Eisenhower Blvd • Tampa, Florida 33634-6391 Telephone: +1 813-884-1411 • Fax: +1 813-886-2794 • http://www.trak.com
SC-CUT OVENIZED CRYSTAL OSCILLATORS
19
TABLE I CONNECTOR VERSIONS Model Number 10-400-9100-000 10-450-9200-000 10-450-9300-000 10-450-9400-000 10-400-9500-000 10-450-9600-000 10-450-9700-000 10-450-9800-000
1.32
Output Power Outline (dBm, min.) Drawing + 10 A + 10 B-1 + 10 B-1 + 10 B-1 + 19 A + 19 B-1 + 19 B-1 + 18 B-1
.09
.09
.75 DC P/N RF
1.50
DC
1.32
GND
S/N
GND
FREQ RF OUT
VT
D/C
.102 DIA THRU 4 PLACES
VT
FREQUENCY TRIM SMA FEMALE CONNECTOR
O S C I L L AT O R S
Frequency Range (MHz) 60-120 121 - 360 361 - 720 721 - 1440 60 - 120 121 - 360 361 - 720 721 - 1440
1.50
.75
Outline A
TABLE II PCB VERSIONS Frequency Range (MHz) 60-120 121 - 360 361 - 720 721 - 1440 60 - 120 121 - 360 361 - 720 721 - 1440
Model Number 10-400-9101-000 10-450-9201-000 10-450-9301-000 10-450-9401-000 10-400-9501-000 10-450-9601-000 10-450-9701-000 10-450-9801-000
Output Power Outline (dBm, min.) Drawing + 10 C + 10 D-1 + 10 D-1 + 10 D-1 + 19 C + 19 D-1 + 19 D-1 + 18 D-1
A B
.75
Model Number 10-400-9110-000 10-450-9210-000 10-450-9310-000 10-450-9410-000 10-400-9510-000 10-450-9610-000 10-450-9710-000 10-450-9810-000
Output Power Outline (dBm, min.) Drawing +8 B-1 +8 B-2 +8 B-2 +8 B-2 + 17 B-1 + 17 B-2 + 17 B-2 + 16 B-2
DC
GND
RF OUT
.102 DIA THRU 4 PLACES
1.32 GND
FREQ
VT FREQ
D/C
ADJ
VT
SMA FEMALE CONNECTOR
.75
- 2 A = 2.75, B = 2.57
-1 A = 2. 25, B = 2.07
Outline B
MODELS WITH IMPROVED HARMONICS & SUB-HARMONICS (- 60 dBc from DC to three times the output frequency) TABLE III CONNECTOR VERSIONS Frequency Range (MHz) 60-120 121 - 360 361 - 720 721 - 1440 60 - 120 121 - 360 361 - 720 721 - 1440
DC
P/N RF S/N 1.50
.09
.09
.75
1.50
1.50
P/N RF S/N FREQ D/C
.16
.09 .09
DC
.480
DC
1.32
RF OUT
.570
.240
VT
O.03 TYP.
VT
2X 0-80 UNF-2B .09 MIN. DEPTH SEE NOTE
1.32
.750
.470 .160
FREQUENCY TRIM
1.190
4X 2-56 UNC-2B .13 MIN. DEPTH
NOTE: FOR PROPER RF GROUNDING, A GROUND PLANE SHOULD BE PROVIDED UNDER THE COMPONENT AND SECURED USING THE 2 MOUNTING HOLES PROVIDED.
Outline C
TABLE IV PCB VERSIONS Frequency Range (MHz) 60-120 121 - 360 361 - 720 721 - 1440 60 - 120 121 - 360 361 - 720 721 - 1440
Model Number 10-400-9111-000 10-450-9211-000 10-450-9311-000 10-450-9411-000 10-400-9511-000 10-450-9611-000 10-450-9711-000 10-450-9811-000
Output Power Outline (dBm, min.) Drawing +8 D-1 +8 D-2 +8 D-2 +8 D-2 + 17 D-1 + 17 D-2 + 17 D-2 + 16 D-2
Options: Options are designated by the last three digits of the model number, with 000 indicating no options. Ordering Information: Specify the model number, options (if any), and the exact operating frequency in MHz to the sixth decimal place.
ABC
.75
A
1.50
P/N RF S/N FREQ D/C
DC
B
.09
.16
2 X 0-80 UNF-2B .09 MIN. DEPTH SEE NOTE .480
DC
1.32
RF OUT
.570 FREQ VT ADJ
.470 .09 .160
O .03 TYP
-1 A = 2.25, B = 2.07, C = 1.94
VT
.240 .750
C
- 2 A = 2.75, B = 2.57, C = 2.44
Outline D Example: Model Number 10-400-9100-012, 100.000000 MHz is a standard 100 MHz oscillator with connector, frequency trim, and extended operating temperature options. Model Number 10-400-9110-012, 100.000000 MHz is the same as the above example except that it also has improved harmonics and sub-harmonics. 4726 Eisenhower Blvd • Tampa, Florida 33634-6391 Telephone: 813-884-1411 • Fax: 813-886-2794 • http://www.trak.com
